3D Studio
Wind Window Simulator
A hemisphere of flyable air with the power zone, the edge and the zenith marked. Drag the kite through it and watch line tension change.
Building the scene
Static reference
The interactive model is not running, so the same figures are listed here.
| Position | Behaviour | Tension | Note |
|---|---|---|---|
| Power zone (0°, 30°) | Maximum pull | 4.1 kgf | Keep clear in strong wind |
| Ideal (0°, 42°) | Steady climb | 2.9 kgf | The default flying position |
| Edge (70°, 30°) | Fast, low pull | 0.9 kgf | Where kites accelerate |
| Zenith (0°, 85°) | Slack line | 0.3 kgf | Where kites fall out of the sky |
| Behind the flyer (150°) | No flyable air | 0 kgf | Outside the window |
These are the values the model computes at the listed settings. Change your own numbers on the calculator page for a specific answer.
What this model shows
Why a kite pulls hardest downwind and sits slack overhead, and where the edge of the window actually is.
How to use it
- Set the wind
- Sweep the window
- Read the tension
What the model leaves out
Real air is not steady, real sails stretch, and real lines creep. This model assumes a constant wind, a rigid frame and a linear line. It is accurate enough to show you which way a change goes and roughly how far; it is not a substitute for taking the kite out and looking at it.
Estimates, not guarantees
Every figure here comes from a simplified model printed on the page. Check the arithmetic if you are making a decision that matters, and never fly near power lines whatever the numbers say.
Outputs
- Best flying zone
- Line tension range
- Risk zones
- Suggested line length
Controls
- Wind speed
- Kite type
- Line length
Drag inside the canvas to orbit. The model pauses when the tab is hidden and stops rendering when it scrolls out of view.
Other studio tools
Bridle Tuner
Drag the bridle nodes, change the left and right leg lengths, and watch a 3D diamond respond — turn, dive, or settle into stable flight.
Kite Builder
Assemble a kite in stages — spine, spreader, sail, bridle, tail — and watch span, area, weight and wind range update as you go.
Line Tension Simulator
Pick a line, set the wind, and watch tension climb toward the breaking point. Run a break test and see where the line actually gives.