3D Studio
Line Tension Simulator
Pick a line, set the wind, and watch tension climb toward the breaking point. Run a break test and see where the line actually gives.
Building the scene
Static reference
The interactive model is not running, so the same figures are listed here.
| Setup | Tension | Safety factor | Verdict |
|---|---|---|---|
| Dacron 80 lb, 12 mph, 0.9 m² | 2.6 kgf | 2.9 × | Within limits |
| Dacron 80 lb, 20 mph, 0.9 m² | 7.2 kgf | 1.1 × | Near the breaking point |
| Dyneema 80 lb, 20 mph, 0.9 m² | 7.2 kgf | 0.85 × | Breaks — knot efficiency 0.56 |
| Kevlar 120 lb, 20 mph, 0.9 m² | 7.2 kgf | 1.4 × | Aramid has no stretch warning |
These are the values the model computes at the listed settings. Change your own numbers on the calculator page for a specific answer.
What this model shows
The gap between a line’s rated strength and the load a gust puts on it — and why knots matter.
How to use it
- Choose the line
- Set the load
- Run the break test
What the model leaves out
Real air is not steady, real sails stretch, and real lines creep. This model assumes a constant wind, a rigid frame and a linear line. It is accurate enough to show you which way a change goes and roughly how far; it is not a substitute for taking the kite out and looking at it.
Estimates, not guarantees
Every figure here comes from a simplified model printed on the page. Check the arithmetic if you are making a decision that matters, and never fly near power lines whatever the numbers say.
Outputs
- Current tension
- Safety factor
- Breaking point
- Suggested line size
Controls
- Line material
- Line rating
- Wind speed
- Kite area
Drag inside the canvas to orbit. The model pauses when the tab is hidden and stops rendering when it scrolls out of view.
Other studio tools
Bridle Tuner
Drag the bridle nodes, change the left and right leg lengths, and watch a 3D diamond respond — turn, dive, or settle into stable flight.
Wind Window Simulator
A hemisphere of flyable air with the power zone, the edge and the zenith marked. Drag the kite through it and watch line tension change.
Kite Builder
Assemble a kite in stages — spine, spreader, sail, bridle, tail — and watch span, area, weight and wind range update as you go.