Lines · Balance

Bridle Line

The 2 mm that decides everything.

Bridle Line — workshop line drawing
Specification
MaterialBraided polyester
Diameter1.5 – 2.0 mm
Break strength40 – 80 lb
AdjustabilityHigh — knots move freely
Knot holdingExcellent
Colour codingLeft / right red and teal
Technical parameters
MaterialBraided polyester
Span / size1.5 – 2 mm
Wind rangeAll ranges
Skill levelAll levels
Balance

What it is

Bridle line is short, lightly loaded and constantly adjusted, so it needs to hold a knot without slipping and tolerate being retied. Braided polyester around 1.5–2 mm is the standard. Anything slicker will creep under load and quietly change your trim mid-flight.

Safety

A bridle that slips is worse than a bridle that breaks, because it fails slowly and quietly. Re-tie rather than re-tension a knot that has been dragged.

Using it

  1. Mark your neutral position with a permanent marker before you change anything.
  2. Colour-code left and right; you will not remember which leg you shortened.
  3. Retie with a figure-eight, not an overhand — it unties cleanly next time.

Compatible with

Wind it suits

5 mph 10 mph 15 mph 20 mph

Wind figures are the range this item is normally used in, not a guarantee. Measure the wind before you launch, and treat the top of the range as a limit rather than a target.

See it in 3D

The gap between a line’s rated strength and the load a gust puts on it — and why knots matter. Open the Line Tension Simulator.