Repair · Build / Store

Kite Patch

A tear stops growing the moment you cover it.

Kite Patch — workshop line drawing
Specification
MaterialAdhesive-backed ripstop
Thickness0.08 – 0.12 mm
AdhesionAcrylic, low-temp
SizesRound 30 / 50 / 80 mm
WeatherUV stable 2 – 3 seasons
ColoursClear, red, white, black
Technical parameters
MaterialAdhesive ripstop nylon
Span / size30 – 80 mm discs
Wind rangeAll ranges
Skill levelBeginner
BuildStore

What it is

Adhesive ripstop patches are the first repair for any sail damage. The important part is the shape: a round or oval patch spreads the load, while a square one concentrates it at the corners and peels from there. Clean, dry and slightly warm is the whole technique.

Safety

A patch on a seam or a spar pocket will fail. If the tear crosses structure, the panel needs sewing, not sticking.

Using it

  1. Cut the patch round; corners are where peel starts.
  2. Clean with alcohol and let it dry fully before applying.
  3. Patch both sides of a tear longer than 5 cm.

Compatible with

Wind it suits

6 mph 12 mph 18 mph 22 mph

Wind figures are the range this item is normally used in, not a guarantee. Measure the wind before you launch, and treat the top of the range as a limit rather than a target.

See it in 3D

How span, sail area and frame stiffness trade against each other, and when a frame becomes too light for the sail. Open the Kite Builder.