Lines · Balance / Fly

Swivel Clip

Thirty grams that stop the line winding itself into a spring.

Swivel Clip — workshop line drawing
Specification
MaterialStainless or brass
Breaking load80 – 250 lb
Length28 – 45 mm
AttachmentLark’s head both ends
Weight4 – 12 g
MaintenanceRinse after saltwater
Technical parameters
MaterialStainless steel or brass
Span / size28 – 45 mm
Wind rangeAll ranges
Skill levelAll levels
BalanceFly

What it is

A swivel sits between the line and the bridle so the kite can rotate without putting a twist into the line. Without one, every loop the kite makes adds a twist that has to be removed by hand. It is the cheapest upgrade on the site.

Safety

A cheap swivel is a single point of failure in the whole system. If the gate does not snap positively, do not fly it.

Using it

  1. One swivel per line, at the kite end, not at the winder.
  2. Check the gate spring every season; they weaken before they fail.
  3. A swivel does not remove twist already in the line — untwist first.

Compatible with

Wind it suits

5 mph 10 mph 15 mph 20 mph

Wind figures are the range this item is normally used in, not a guarantee. Measure the wind before you launch, and treat the top of the range as a limit rather than a target.

See it in 3D

The gap between a line’s rated strength and the load a gust puts on it — and why knots matter. Open the Line Tension Simulator.