Calculator

Line Length & Wind Calculator

Work out how much line a target height needs, what tension that puts on the line, and whether the wind is inside the safe band.

Inputs

Tip to tip, in inches.

Measure at flying height if you can.

Metres above the ground.

Suggested line length

—
metres
Estimated tension
—
Recommended line
—
Best flying angle
—
Estimated sail area
—
Tension vs rating
—

0limit

L = h / sin(θ) · T = ½ρv²·A·Cd · Cd = 1.15 · gust factor 1.6 · safety factor 2

How this is calculated

Line length comes from the target height and a typical flying angle for the kite type: a delta sits higher in the window than a sport kite, so it needs less line for the same height. Tension uses the standard drag equation with a flat-plate coefficient, then a gust factor of 1.6 because a steady wind is not what breaks lines.

The recommended line is the smallest standard size whose knotted rating clears the gust tension twice over. Knots cost 20–50 % of a line’s strength, so the model never uses the number printed on the spool.

What this cannot tell you

It does not know your line’s age, its abrasion, or the real sail area of your kite. Treat the result as a starting size, then go one step up if you are unsure.

Outputs

  • Suggested line length
  • estimated tension
  • line size
  • best flying angle
  • risk notes

About the figures

These are planning estimates from a simplified model, printed with the formula so you can check the arithmetic. They are not a measurement of your kite, your line or your wind.

Before you launch

Never fly near power lines. Do not fly in wind above 20 mph. Wear gloves if the wind is above 12 mph. Check your local rules for the site.