Repair · Build / Balance

Spreader

The bar that holds a kite’s shape under load.

Spreader — workshop line drawing
Specification
MaterialCarbon or fibreglass tube
Diameter4 – 8 mm
Length400 – 900 mm
FittingsFerrule or end cap
LoadHighest in the frame
SparesCarry two
Technical parameters
MaterialCarbon or fibreglass tube with ferrules
Span / size400 – 900 mm
Wind rangeAll ranges
Skill levelBeginner – intermediate
BuildBalance

What it is

A spreader is the cross bar that keeps the leading edges apart on a delta or a sport kite. It is the most highly loaded part of the frame and the one that breaks first in a hard landing. Carry a spare of the correct length; a spreader 2 cm short changes the whole sail tension.

Safety

A split carbon spreader leaves splinters that go straight through a sail and into a hand. Tape over any damage and replace it.

Using it

  1. Mark the correct length on the kite bag so a replacement is exact.
  2. Tape the ferrule joint; a spreader that separates mid-flight shreds the sail.
  3. Carbon fails suddenly, fibreglass bends first — carry the one your kite was designed for.

Compatible with

Wind it suits

6 mph 12 mph 18 mph 24 mph

Wind figures are the range this item is normally used in, not a guarantee. Measure the wind before you launch, and treat the top of the range as a limit rather than a target.

See it in 3D

How span, sail area and frame stiffness trade against each other, and when a frame becomes too light for the sail. Open the Kite Builder.