3D Studio
Kite Builder
Assemble a kite in stages — spine, spreader, sail, bridle, tail — and watch span, area, weight and wind range update as you go.
Building the scene
Static reference
The interactive model is not running, so the same figures are listed here.
| Build | Sail area | Mass | Wind range |
|---|---|---|---|
| 110 cm delta, carbon, ripstop | 0.51 m² | 148 g | 7 – 17 mph |
| 110 cm delta, wood, polyester | 0.51 m² | 312 g | 10 – 19 mph |
| 160 cm delta, carbon, icarex | 1.08 m² | 204 g | 5 – 15 mph |
| 60 cm diamond, wood, ripstop | 0.15 m² | 96 g | 8 – 18 mph |
These are the values the model computes at the listed settings. Change your own numbers on the calculator page for a specific answer.
What this model shows
How span, sail area and frame stiffness trade against each other, and when a frame becomes too light for the sail.
How to use it
- Spine
- Spreader
- Sail
- Bridle
- Tail
What the model leaves out
Real air is not steady, real sails stretch, and real lines creep. This model assumes a constant wind, a rigid frame and a linear line. It is accurate enough to show you which way a change goes and roughly how far; it is not a substitute for taking the kite out and looking at it.
Estimates, not guarantees
Every figure here comes from a simplified model printed on the page. Check the arithmetic if you are making a decision that matters, and never fly near power lines whatever the numbers say.
Outputs
- Span
- Frame length
- Sail area
- Total weight
- Wind range
Controls
- Kite type
- Span
- Frame material
- Sail material
- Colour
Drag inside the canvas to orbit. The model pauses when the tab is hidden and stops rendering when it scrolls out of view.
Other studio tools
Bridle Tuner
Drag the bridle nodes, change the left and right leg lengths, and watch a 3D diamond respond — turn, dive, or settle into stable flight.
Wind Window Simulator
A hemisphere of flyable air with the power zone, the edge and the zenith marked. Drag the kite through it and watch line tension change.
Line Tension Simulator
Pick a line, set the wind, and watch tension climb toward the breaking point. Run a break test and see where the line actually gives.