3D Studio
Bridle Tuner
Drag the bridle nodes, change the left and right leg lengths, and watch a 3D diamond respond — turn, dive, or settle into stable flight.
Building the scene
Static reference
The interactive model is not running, so the same figures are listed here.
| Setup | Behaviour | Stability | Fix |
|---|---|---|---|
| Neutral bridle (0 / 0, tow 0) | Flies straight | 95 / 100 | Leave it alone |
| Right leg +1.0 cm | Turns left | 74 / 100 | Shorten the right leg by 1 cm |
| Right leg +2.5 cm | Spinning | 28 / 100 | Equalise the legs before flying |
| Tow point −3 cm | Dives | 61 / 100 | Move the tow point back 1 cm |
| Tow point +3 cm | Climbs, stalls | 58 / 100 | Move the tow point forward 1 cm |
These are the values the model computes at the listed settings. Change your own numbers on the calculator page for a specific answer.
What this model shows
Why 1–2 cm of bridle asymmetry is enough to make a kite spin, and what a neutral tow point looks like.
How to use it
- Measure both legs
- Launch and watch
- Trim one leg at a time
What the model leaves out
Real air is not steady, real sails stretch, and real lines creep. This model assumes a constant wind, a rigid frame and a linear line. It is accurate enough to show you which way a change goes and roughly how far; it is not a substitute for taking the kite out and looking at it.
Estimates, not guarantees
Every figure here comes from a simplified model printed on the page. Check the arithmetic if you are making a decision that matters, and never fly near power lines whatever the numbers say.
Outputs
- Bridle ratio
- Tow point
- Stability score
- Suggested adjustment
Controls
- Left bridle length
- Right bridle length
- Tow point
- Wind speed
Drag inside the canvas to orbit. The model pauses when the tab is hidden and stops rendering when it scrolls out of view.
Other studio tools
Wind Window Simulator
A hemisphere of flyable air with the power zone, the edge and the zenith marked. Drag the kite through it and watch line tension change.
Kite Builder
Assemble a kite in stages — spine, spreader, sail, bridle, tail — and watch span, area, weight and wind range update as you go.
Line Tension Simulator
Pick a line, set the wind, and watch tension climb toward the breaking point. Run a break test and see where the line actually gives.