Lines · Store / Fly

Line Winder

Where line goes when it is not in the air.

Line Winder — workshop line drawing
Specification
Capacity100 – 300 m of 50 lb
MaterialABS or birch ply
Throat depth18 – 25 mm
HandleFixed or free-spinning
Line sizes20 – 150 lb
Weight60 – 140 g
Technical parameters
MaterialABS, polypropylene or birch ply
Span / size180 – 260 mm across
Wind rangeAll ranges
Skill levelAll levels
StoreFly

What it is

A winder is a handle with two flanges. The good ones have a deep throat so line does not jump the flange, a smooth radius so the line does not take a set, and a hole for the end. A bad winder puts a kink in your line every time you wind in under tension.

Safety

Never wind line onto a winder while the kite is still loaded — the line can slice across the flange and into a finger.

Using it

  1. Wind in a figure-eight for dual-line sets so the lines do not take a twist.
  2. Tape the free end to the winder; loose ends tangle in the bag.
  3. Rinse a saltwater winder and dry it before storing.

Compatible with

Wind it suits

6 mph 12 mph 18 mph 22 mph

Wind figures are the range this item is normally used in, not a guarantee. Measure the wind before you launch, and treat the top of the range as a limit rather than a target.

See it in 3D

The gap between a line’s rated strength and the load a gust puts on it — and why knots matter. Open the Line Tension Simulator.