Repair · Build

Spine Rod

The centre line the whole kite hangs from.

Spine Rod — workshop line drawing
Specification
MaterialCarbon, fibreglass or bamboo
Diameter3 – 6 mm
Length600 – 1400 mm
FlexMatched to sail area
EndsFerrule + nose cap
SparesOne per kite
Technical parameters
MaterialCarbon, fibreglass or bamboo
Span / size600 – 1400 mm
Wind rangeAll ranges
Skill levelBeginner – intermediate
Build

What it is

The spine runs nose to tail and carries the bridle load into the sail. It sets the kite’s camber and its stiffness. Too soft and the nose folds in a gust; too stiff and the kite refuses to bend and spills wind instead.

Safety

A spine that is too long pre-loads the sail and splits the nose pocket on the first gust. Measure against the old rod.

Using it

  1. Match the flex to the sail: bigger sail, stiffer spine.
  2. Check the nose cap — a missing cap saws through the sail.
  3. Store spares straight; a rod that lives bent stays bent.

Compatible with

Wind it suits

6 mph 12 mph 18 mph 22 mph

Wind figures are the range this item is normally used in, not a guarantee. Measure the wind before you launch, and treat the top of the range as a limit rather than a target.

See it in 3D

How span, sail area and frame stiffness trade against each other, and when a frame becomes too light for the sail. Open the Kite Builder.