Kites · Build / Balance

Diamond Kite

The rhombus that taught everyone else to fly.

Diamond Kite — workshop line drawing
Specification
Sail area0.55 – 0.95 m²
Frame1 spine, 1 cross spar
Bridle2-leg, tow point 38 – 45 % down the spine
TailRequired above 10 mph
Pack size110 cm rolled
Typical price bandEntry
Technical parameters
MaterialRipstop nylon sail, 6 mm fibreglass frame
Span / size30 – 48 in (76 – 122 cm)
Wind range6 – 16 mph
Skill levelBeginner
BuildBalance

What it is

A single-spar diamond with a cross spar and a two-leg bridle. Slow, forgiving and cheap to make, which is why it is still the default first kite. The trade is that it needs a tail in anything above a light breeze and will not tolerate a sloppy bridle.

Safety

A diamond pulls hardest at the top of its wind range. Above 16 mph the frame starts to bow and the sail will tear at the cross-spar pocket — land it rather than proving the point.

Using it

  1. Set the tow point at about 40 % of the spine length from the nose, then move it 1 cm at a time.
  2. Check that both bridle legs are the same length before you blame the wind.
  3. A tail 3–4 times the kite height kills spin without making the kite sluggish.

Compatible with

Wind it suits

6 mph 10 mph 14 mph 16 mph

Wind figures are the range this item is normally used in, not a guarantee. Measure the wind before you launch, and treat the top of the range as a limit rather than a target.

See it in 3D

How span, sail area and frame stiffness trade against each other, and when a frame becomes too light for the sail. Open the Kite Builder.