Kites · Build / Fly
Box Kite
Two cells, four long spars, and a lot of lift.
| Cell size | 30 × 30 cm typical |
|---|---|
| Frame | 4 longerons, 8 cross braces |
| Bridle | Single point, 2 legs to the front cell |
| Wind range | 8 – 22 mph |
| Assembly | 5 – 8 min |
| Pack size | Long bundle, 1 m+ |
| Material | Ripstop nylon, 6 – 8 mm dowel or carbon longerons |
|---|---|
| Span / size | 24 – 36 in per cell |
| Wind range | 8 – 22 mph |
| Skill level | Intermediate |
What it is
A box kite is a pair of open-ended cells braced by four longerons. The cells let air through instead of trapping it, which gives a high lift-to-drag ratio and a very steady pull. It is heavier and slower to assemble than a flat kite, and it does not fold small.
Safety
A box kite pulls steadily and hard; it is the kite most likely to drag a small child. Use a stake or an anchor in wind above 15 mph.
Using it
- Sight down the longerons before flying — a twisted cell turns into a spiral.
- Box kites fly best a little higher than you think; let line out until the pull steadies.
- Do not shorten the bridle to make it climb faster; it will just luff.
Compatible with
Wind it suits
Wind figures are the range this item is normally used in, not a guarantee. Measure the wind before you launch, and treat the top of the range as a limit rather than a target.
See it in 3D
How span, sail area and frame stiffness trade against each other, and when a frame becomes too light for the sail. Open the Kite Builder.
Related
Four pages that pair with this one.