Adding Tails: When, Why, and How Long

Tails are drag, and drag is a tool. How to size one, why two short tails beat one long one, and when a tail is hiding a real problem.

A tail is drag. That is the whole physics, and everything else follows from it: drag behind the centre of gravity damps rotation, which stops a kite hunting left and right. Drag also costs height, which is why more tail is not better.

The skill is adding just enough, in the right shape, for the wind you actually have.

What a tail fixes, and what it does not

A tail fixes yaw oscillation — the left-right hunting that makes a kite look unstable. It also helps in gusty wind, because it slows the kite’s response to a sudden change in angle of attack.

A tail does not fix a diving kite (that is a tow point problem), a spinning kite (that is bridle symmetry), or a kite that will not launch (that is wind or weight). Putting a tail on a kite with a bridle problem makes a slow kite with a bridle problem.

Diagnose before you decorate

If the kite spins consistently in one direction, it is not a tail problem. A tail damps oscillation; it cannot correct a permanent bias.

Sizing a tail

Start with a tail three times the kite’s height — about 3 m for a 1 m diamond. Add length in increments of one kite-height only if the kite is still hunting. Stop at the first length that settles it.

Two shorter tails damp better than one long one, because they act at two points rather than one, and they are less likely to wrap around the line in a spin.

Adding Tails: When, Why, and How Long
WindTail lengthTypeNote
5–8 mphNone or 2 mRibbonA tail costs height in light air
9–13 mph3–4 mRibbon, two stripsThe default setup
14–18 mph4–6 mRibbon or tubeTube adds more drag per metre
19 mph +6 m+ or tubeTubeIf it still hunts, the kite is too big for the wind
Add tail length and watch the yaw oscillation damp out — then watch it start to cost height.

3D demo · scroll to load

STATIC
60 cm
Add tail length and watch the yaw oscillation damp out — then watch it start to cost height.

Ribbon versus tube

A ribbon is a flat strip. It produces moderate drag, it works in light wind, and it is cheap. It also frays and it wraps around the line when the kite spins.

A tube is a tapered fabric cone that inflates. It produces far more drag per metre, so you need less length — but it will not inflate below about 8 mph, and it holds water. Use tube tails for genuinely unstable kites and gusty days, ribbons for everything else.

Attachment, and the mistake everyone makes

Attach the tail to the tail point at the base of the spine, using a lark’s head through the grommet. Not to the bridle, and not to a spar — both will tear out under load.

The common mistake is attaching a tail to a kite that is already flying well and then wondering why it now sits lower and climbs slower. A tail is a fix, not an upgrade. If the kite flies straight without one, leave it off.

When a tail is hiding a problem

A kite that needs an enormous tail to fly straight has a frame or bridle problem. A bent spine, a spreader that is too short, or a bridle that is off-centre will all show up as instability that a tail can mask. Masking it costs you performance, and the underlying fault gets worse.

If the tail you need is longer than about five times the kite height, stop adding tail and check the frame.

Kite & Wind

An independent reference, written from the geometry and checked against a wind meter. No ads, no shop, no sponsored materials. Corrections go to [email protected].

PreviousLine Selection: Dacron, Dyneema, and KevlarNextRepairing a Torn Kite: Patches and Rods