Knot & Rigging MARITIME TOOLKIT
3D Studio

3D STUDIO

Knot Tying Simulator

A parametric 3D rope you can rotate, work and tighten, with guided steps for four working knots and an honest readout of what each one costs in strength.

INTERACTIVE LOADING

∞ BUILDING MODEL

Loading the 3D library on demand.

Knot Tying Simulator — static reference diagram

Static reference view

The interactive model is not available on this device, but the diagram and every figure on this page are.

Drag to rotate Scroll to zoom

Parameters

Readout

Retention figures come from the same table the calculator uses. A wrong step is reported rather than hidden.

∞ HOW TO WORK IT

Step by step

  1. Form the initial loop in the standing part.
  2. Pass the working end up through the loop.
  3. Take the working end around behind the standing part.
  4. Bring it back down through the loop and dress the knot.
  5. Tighten progressively, working from the standing part outward.

∞ WHAT IT REPORTS

Outputs

  • Strength retention
  • Rope length needed
  • Tightening time
  • Correctness score

Controls

Rope diameterKnot typeTightnessView angle

Modes

BowlineFigure-eightClove hitchSheet bend
This is an educational model with simplified geometry and physics. Results are indicative only and are not a rating, a certification or a substitute for the equipment instructions. Never rely on a simulation for a real lift, a real splice or a real load.

∞ MORE 3D

Other studio tools

Rope Load Simulator — interactive 3D model
INTERACTIVE

Rope Load Simulator

Hang a load on a line and watch tension, stretch and the point of failure.

3D Studio
Splice Simulator — interactive 3D model
INTERACTIVE

Splice Simulator

Work a three-strand eye splice or short splice, tuck by tuck.

3D Studio
Rigging Load Visualizer — interactive 3D model
INTERACTIVE

Rigging Load Visualizer

See where the load goes in a rig — vectors, angles and the weakest point.

3D Studio